Light

PK 8501 High Performance

Loader Crane

With the appropriate auxiliary equipment, this crane becomes a multifunctional work machine

Maximum utilisation of the working range due to HPSC
More lifting power due to E-HPLS
High operator friendliness thanks to optional radio remote control
High value retention thanks to coating technology
Higher payloads due to intelligent lightweight design

Technical Data

Low-maintenance extension system

With sliding elements made of synthetic material and the high-quality KTL coating, this boom system significantly simplifies service performed by the operator. This saves time and money – and protects the environment.

High Speed Extension

The High Speed Extension is a standard feature on PALFINGER loader cranes. Also referred to as Return Oil Utilization, this feature is a regenerative hydraulic circuit for the extension booms. It speeds up the boom extend and retract functions by up to 30%.

Single Link

The knuckle joint significantly improves the crane’s motion geometry.

Technical data
Lifting capacities

Max. lifting moment	7.8 mt
Max. lifting capacity	5700 kg
Max. hydraulic outreach	14.0 m
Slewing angle	400°
Slewing torque with 1 gear	1.0 mt
Stabilizer spread (std)	32 m
Fitting space required (std)	0.69 m
Width folded	2.32 m
Max. operating pressure	320 bar
Pump capacity	25 - 35 l/min
Dead weight (std)	1022 kg

Cranes shown in the leaflet are partially optional equipped and do not always correspond to the standard version.
Country-specific regulations must be observed. Dimensions may vary. Subject to technical changes, errors and translation mistakes.

	Lifting moment (mt)	Outreach (m)	Slewing angle (°)	Slewing torque (mt)	Pressure (MPa)	Pump capacity (l/min)	Crane Weight (kg)	Crane Height (mm)	Crane Width (mm)	Installation Width (mm)
Std	7.8	5.6	400°	1.0	32.0	25 - 35 l/min	1022	2004	2320	690
A	7.6	7.6	400	1.0	32.0	25-35	1119	2004	2320	690
B	7.3	9.7	400	1.0	32.0	25-35	1224	2004	2320	690
C	7.1	11.8	400	1.0	32.0	25-35	1320	2004	2320	690
D	6.8	14.0	400	1.0	32.0	25-35	1416	2030	2340	730

The outreaches stated are with a boom angle of 20° and are therefore not the maximum. When using mechanical boom extensions, the loads shown on the charts need to be reduced by the weight of these extensions.